JBL VM300

9,720,000 ₫In stock

Delivery & payment

Pickup at the school: Free · 9:00–21:00
Ho Chi Minh City: Fee confirmed with your order
Across Vietnam: Courier · fee confirmed by phone
Payment: VietQR · cash on delivery · pay at the school

Warranty Genuine product, official warranty, 7-day exchange for factory faults.

Warranty policy · Refunds, cancellations and returns

Spec sheetJBL · VM300

Type: UHF wireless mic system: 1 × SR300 receiver, 2 × HT300 handheld mics
Capsule: Dynamic
Frequency band: UHF 640–690 MHz
Channels: 200; 250 kHz steps; PLL synthesised
Bandwidth: 50 MHz
Frequency deviation: ±10 kHz
RF power: ≤ 30 mW, High/Low
Operating range: ≈ 50 m
S/N ratio: ≥ 50 dB
Receiving mode: CPU-controlled selection + pilot tone detection; mute & lock loop circuit
Outputs: 2 × balanced XLR, 1 × unbalanced 6.35 mm TS
Features: Preset, Auto Scan, Shake to Sync, Auto Mute (≈ 3 s), Auto Wakeup, Auto Sleep (≈ 8 min)
Display: LCD on the receiver and on each mic
Power: Receiver 12 V DC, 1.25 A; mics on AA batteries
Shipping weight: 2.5 kg
In the box: 2 antennas, power adapter, 6.35 mm audio cable, 2 anti-roll rings, 4 × AA batteries, quick start guide

Description

The JBL VM300 is a UHF wireless microphone system with one SR300 receiver and two HT300 handheld dynamic microphones. JBL designed it for karaoke and KTV rooms, gave it a vocal tuning of its own and presents it as a companion to the brand's karaoke speakers.

Highlights

UHF band 640–690 MHz with 200 channels in 250 kHz steps and PLL frequency control.
Operating range of about 50 m; transmitter power up to 30 mW with High and Low settings.
Auto Scan looks for clean frequencies, and Shake to Sync sets both microphones at the same time.
Auto Mute silences a microphone left still for about 3 seconds, Auto Sleep switches it off after about 8 minutes, and it wakes when picked up.
LCD screens on the receiver and on each microphone show status and battery level.
Two balanced XLR outputs and one unbalanced 6.35 mm output.

In your setup

Connect the two XLR outputs to two channels of a mixer or karaoke amplifier so each voice has its own level and EQ; if the amplifier has only one input, use the 6.35 mm output with the supplied cable. Preset mode picks a matching pair of frequencies for channels A and B in one step, so setup is quick. The receiver runs on its 12 V DC adapter, and the microphones take AA batteries; four are included. Rubber rings stop the microphones from rolling off a table.